拉霸LaBa360

Chinese
  • Home
  • About
  • News
  • Product
  • Customer service
  • Job
  • Contact
  • Chinese
  • x

    News

    Guide for installation of light strips

    Date: 2021-10-15



    1, indoor installation: LED light belt for indoor decoration, because do not have to withstand the wind and rain, so the installation is very simple. Take the LED light strip produced by Guang Hong Electronics as an example. Each LED light strip has a self-adhesive 3m double-sided adhesive tape on the back. When installed, the sticker on the surface of the 3m double-sided adhesive tape can be torn off directly, and then the light strip can be fixed at the place where it needs to be installed, just flatten it with your hand. As for some places need corner or long how to do, it is very simple, LED light strip is a series of three LED for a group of parallel circuit structure, every three LED can be cut off to use alone.


    2, outdoor installation: outdoor installation due to exposure to wind and rain, if the use of 3m glue fixed, a long time will cause 3M adhesive reduced and LED light strip off, so the outdoor installation often use card slot fixed way. Where shear and connection are required, the method is the same as for indoor installation, except that additional waterproofing glue is required to reinforce the connection points.


    3, Power Connection method: the general voltage of LED lamp strip DC 12V, so need to use switching power supply, power supply according to the size of LED lamp strip power and connection, length to determine. If you don’t want every LED strip to be controlled by a power supply, you can buy a high-power switching power supply as the total power supply, then all the LED lights with input power all connected in parallel (wire, size is not enough to be extended) , unified by the total switching power supply. The advantage is that can be centralized control, inconvenient place is not to achieve a single LED strip lighting effect and switch control, which specific, which way can be measured by themselves.


    4, controller connection: LED and RGB full color band need to use controllers to achieve the illusion, and each controller control distance is not the same, in general, simple controller control distance of 10 to 15 meters, the remote controller has a range of 15 to 20 meters and can be controlled up to 30 meters. If the LED strip has a long connection distance, and the controller can not control the length of the strip, then a power amplifier is needed for the tap.


    5. Note the connection distance: in general, 3528 series LED lights, the longest connection distance is 20 meters, 5050 series LED lights, the longest connection distance is 15 meters. If beyond this connection distance, then the LED light band is very easy to heat, the use of the process will affect the life of the LED light band. Therefore, the installation must be in accordance with the manufacturers, the requirements of the installation, do not let the LED lights with overload operation.


    Previous: 已经没有了

    Next: Principle of LED light bead

    拉霸LaBa360